Activity

It is essential when installing toilet or shower cubicles to follow procedures. Preparation is the vital thing and to over look these simple instructions might cause big problems down the road in the installation process. Now ensure you supply the ingredients required to install your cubicle. Just follow these obvious to see instructions, ensuring your lines are vertical because you have areas like floors or walls, which can be from true, plus your cubicles is going to be positioned in virtually no time in any way. 

Step 1 Measuring up

Measure and mark off a vertical line on the back wall for your positions with the wall partitions for that cubicles. Mark around the wall the positions to correct a few back wall brackets.

Step 2 Fitting Brackets

Fix the back wall channel brackets as essential for each partition on the vertical line drawn on the wall.

Step 3 Fitting Partitions

Position the wall panels in the brackets and be sure the partition is level while using adjustable legs fixed towards the wall panels.

Draw the actual position with the holes within the channel brackets around the walls of each partition ready for drilling. Drill the hole by using a 10mm drill bit and fix the brackets to the partition walls while using T-nuts provided.

Step 4 Fitting Partition Support

Check the attached the adjustable leg for the partition, and accommodate correct height. Ensure the partition is aligned correctly and connect adjustable legs on the floor.

Step 5 Fitting Fascia Panels

Measure up and mark off a vertical line around the side wall if fixing with a wall. Fix the three wall brackets the wall. Make sure the hinge panel is level and mark over positions in the 3 brackets about the fascia. Fix the hinge wall to fascia channel brackets while using T-nuts provided. Your pilaster (central fascia panel) will have the hinge holes pre-drilled and merely fix those using the T-nuts provided.

Step 6 Fitting Head Rail

With the partitions and fascia fixed the top rail has to be used in position on the tops in the fascia bridging the door gap. Fix your head rail permanently by attaching on the fascia.

Step 7 Fitting the doors, hinges and lock assembly

Attach the hinges towards the doors. Attach the indicator bolt to the door. Block the doors up for the level in the hinge panel bottom using wood and set the doorway around the blocks. Engage the lock and mark from the indicator bolt around the fascia on the point you would like to attach the keep. faux stone wall panels cheap from the hinge placement about the hinge panel. To drill the hinge holes get rid of the nut at the bottom in the hinge and reassemble and attach the hinges for the walls ensuring the entranceway is hung horizontal. Unlock the indicator bolt and attach the keep while using fixings provided. Set back the plastic sleeves in the hinge for your door to shut closed or open.